CC:113 Change Part (Aeros Only) in 2x2 (Firmw 5.2.1)

CC:113 values 101-106 Change part (Aeros only)

In 2x2, it doesn’t begin the transition to part according to the Change Part setting (Immediately/End of Measure/End of Loop)

Instead of that, it always does Inmediately, no matter what the Change Part setting is.

Works as expected in 6x6, though.

Hi Ed,

Thank you for this information! I’ve reported the issue to the dev team. In the meantime, I recommend using CC:113 with the following values:

Switch Parts Immediately 71-76 Switches parts immediately when receiving this command, this command does not require a CC113 value 0 command to transition. (Part # = value # - 70)
Switch Parts End of Measure 81-86 Switches parts at the next end of measure (EOM) when receiving this command, this command does not require a CC113 value 0 command to transition.
Switch Parts End of Loop 91-96 Switches parts at the next end of loop (EOL) when receiving this command, this command does not require a CC113 value 0 command to transition.

Thank you, Daniel.

I would like to take this opportunity to ask you why/if the CC:113 functions related to Oneshot Part (Aeros Only) (values 111-116) have been rolled back in the latest 5.2.1 firmware.

I am referring specifically to this image I’ve found reading this same forum:

I’m not sure if this was simply a user suggestion or features that were scrapped before 5.2.1 was released.