How to start Aeros recording or playback after the BeatBuddy 2 intro

Hello everyone,

When using the Aeros as MIDI Master and the BeatBuddy 2 as MIDI Slave, I haven’t found a way to make the Aeros wait until the BeatBuddy 2 intro has finished before starting playback or recording.

After pressing the RECORD footswitch, the Aeros starts recording from the first measure while the BB2 is still playing its intro.

Have you encountered this issue? Is there a way to make the Aeros start on the first beat of the main rhythm (i.e. after the intro has finished playing), or is this a limitation of the Aeros Master configuration?

I have the feeling that Aeros Master is better suited to its mini-DAW role, while BB2 Master / Aeros Slave is better suited to traditional looping.

How do you use your Aeros & BB2?

Thanks for your feedback!

Hey there,

Unfortunately, you cannot both have the Aeros as master and use the BeatBuddy’s intro the same way

This is because the Aeros is now leading the sync

The best workaround you can do is to always make sure the BeatBuddy 2 song intro is full measures (using the BBMO this is not too difficult), no partial measures or it will cause a desync. Then you would press the Start/Stop all button on the Aeros to start the looper playback without recording anything. This will give you one measure to start a recording.

So the steps:

  1. Tap Play/Stop All on the Aeros while song is blank
  2. The BeatBuddy will play the Intro automatically, following the Aeros’ outgoing MIDI Start command. (Reminder, if the BeatBuddy intro does not have full measures, this will not work and will cause a desync)
  3. Before the end of the measure (the end of the intro), tap the Track button (RPO) on the Aeros to set up a recording
  4. This will start a recording at the start of the next measure right after the end of the intro

This workaround allows you to pretend to start the BeatBuddy first, but in reality the Aeros starts playback just doesn’t start recording, and you start the recording at the next measure

Let me know if this is helpful for your use case!

Thanks for the question