I have spent around 6 hours on this now, have searched forums but because it’s difficult to explain I can’t seem to get any results.
First off I am not a comprehensive user, I will tend to uses a BB drum pattern and record 2 tracks on the Aeros for jamming over.
OK this is what was happening yesterday
2x2 mode.
Use a drum rhythm from BB
Part 1 of this recording has 2 tracks and is OK, Straight 12 bar.
On Part 2
I record a 12 bar on track 1. Listen to it and it’s fine.
Record another 12 bar track on track 2
Listen to it and decide I want to re-record track 2
So press and hold undo.
Press record, and wait for the loop to complete and then re-record track 2
Once that’s done I listen to it a few times and it’s fine.
All good up until this point
Now, without stopping I will go back to Part 1, listen to it in it’s entirety and then move back to track 2
It starts fine but about 4 bars or so (this is not consistent, seems random) it will start to add bits, bits that may have come from the previous recording of that track.
After I found the issue I was experimenting and sometimes there were a couple of bars just empty but this maybe because I may recorded a track with no sound on it. (I was trying to use logic to narrow down the issue)
I do hope that makes some sort of sense?
What I did as a sort of workaround was.
At the point before I moved back to track 1 and then returned to track 2. (So when it was all OK), I saved the song. It then appeared to then work.
For something so simple it became very frustrating as you can imagine.
If you need me to clarify anything let me know, I have tried to explain it in as simple way as I can.
Steve