Aeros looping to two amps

[Cornelius1]

Hi,

Sorry if this has been adressed, but could’nt find a solution.

I am running two guitars into the Aeros looper, and the output is to two amps. When playing, guitar A plays through amp A, and guitar B plays through amp B - great. While recording a loop, the same thing A to A and B to B (still great), but as soon as the recording is done and the loop is playing back, the loop plays through BOTH amps A and B.

Running firmware 5.3.4. Audio output is set to Stereo. I have tried setting the input format to both mono and stereo - it still plays L and R output simultaneously to both amps when the loop starts playing.

How do I play a loop recorded by Guitar A only to amp A, and by Guitar B only to amp B?

Thanks in advance!

[persist]

Split Aeros Audio Outputs?

I figure this is a long shot, but I’ll give it a go. Wondering if there’s anyway to split the audio outputs of the two loops in 2 x 2 mode. I have a bass line looped in one of the loops, and I’d like to send it to a dedicated bass amp. Also play keyboards, and would like to be able to send the keyboard output and loops through the other audio output to a different amp. Each would be in mono, of course, which is okay with me. Thanks. Tom