First, check out the BB midi command sheet:
- Start BB part 1, 2 etc
You will need to set the MM to send two commands for each part change, the first command must be a CC113 value 1-100 command. Value 1 starts the transition for Part 1, Value 2 for part 2, etc. This command must be on the press. You will then place a CC113 value 0 command on the release, this will tell the BeatBuddy to switch to the selected part at the beginning of the next measure. The Aeros, (in 3.1.3) responds to CC113 value 1-6, but this value does not start it from a stopped state. This is because the BeatBuddy will start the Aeros, and if the Aeros starts without the BB, there will be a sync issue. CC113 values 101-106 will act like a Next Part command on the Aeros and will also start it from a stopped state. - Arm next track on Aeros for record/overdub
There is an Aeros Record New Track command on CC41 value 0, this is only applicable if you are using the Aeros Beta 3.1.3, there are no MIDI commands available on 3.0.0. You can find all the MIDI CC numbers on that thread. - Go to second Mute page
You must set this button to redirect to page 2, it does not have to have additional commands on it. - Mute/Unmute track 1, 2 etc.
The mute commands for the Aeros are:
Mute - CC:38
- Value 1-6: Mutes/Unmutes track (track # = value #)
- Value 0 - Mutes all tracks
- Value 127 - Unmutes all tracks
- Mute/Unmute BB
This is not something you can do simple unless you mean the mute-pause function on the BB. BB must have mute pause enabled in the settings. Then use CC111 (0-127) to engage/disengage the mode. - Go back to Tracks page
Same as the other set-up, you must redirect back to page 1
Please let me know if you have any other questions!