I can confirm that from day 1, when I developed the Hammond and Bass kit, the BB always kept the right and left side unsummed. I have 2 BB pedals, one with the old printing and one with the new, and it is the same on both pedals. I had believed that since the Singular kits were center panned, that the non-summing was a decision on your part that summing was unnecessary. But, if you are certain that summing was intended, then that would appear to be a flaw in all units.
That could be. That was my impression owing to way the left and right outs worked. I only got pan when I programmed in it, by panning drums in varying degrees, and using both outputs.
We have changed the behavior of stereo and mono in the firmware, it really depends what you mean by contain the entire stereo image in mono, do you mean recording and stereo by writing the recording to the Aeros in mono? Could you be more specific what you’re trying to achieve?
The original question was regarding the BB handling of the L/R into a summed mono, not the Aeros. I do not believe you have made any improvements to the BB in this regard. Although given the topic, @KevinT may have been referring to the abilities of the Aeros.
Oh you’re right, I think someone made a mistake when placing it, I’ll put it in the correct place. To your point, I know that this is something we have already fixed in a tested version of the BB.
We’re looking for summed mono in the left output if it’s the only jack plugged in. I BELIEVE this used to work in early editions of the firmware, but others say no.
We did not create a detection method, simply because it would become very complicated and we found it best to use a setting. The setting is to send audio out in mono or in stereo, the setting affects both the headphone out and the left and right outs of the BB.
Am I missing something because my BB works fine on the L/Mono. But I’m not listening to it through a stereo setup either. It goes into a live mixing board on a single channel which is sent to left and right speakers, but it not panned in any way. But i don’t detect anything missing.
There are certain (but not all) user-created one-press drum sets with bass (OPB) that the drums are panned to one side and the bass to the other. I don’t believe the default drum sets have any panning. This is why you may not hear the issue that some users have reported.